EASy68K
http://www.easy68k.com/EASy68Kforum/

Disable SIMHALT toggle
http://www.easy68k.com/EASy68Kforum/viewtopic.php?f=9&t=1254
Page 1 of 1

Author:  jezzirolk [ Mon Nov 25, 2013 8:00 pm ]
Post subject:  Disable SIMHALT toggle

i am writing a monitor software for a project at university and this software is supposed to be able to execute other peoples code. so if i get the code loaded in and everything i can run it properly but the issue is when i try to run code from memory address that doesn't have code i want it to give me the standard F-op code exception as apposed to just stopping the simulator. but looking at your reasoning for adding the SIMHALT i don't think you should get rid of it but just adding the ability to disable it would be useful.

--jezzirolk

Author:  profkelly [ Wed Nov 27, 2013 9:36 pm ]
Post subject:  Re: Disable SIMHALT toggle

Added to EASy68K v5.14.0

Embed the comment *[sim68k]SIMHALT_OFF in the source. This will force the simulator to treat the opcode $FFFF FFFF as a normal "Line F" exception.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/