EASy68K
http://www.easy68k.com/EASy68Kforum/

Log file output
http://www.easy68k.com/EASy68Kforum/viewtopic.php?f=8&t=1019
Page 1 of 1

Author:  lee [ Wed May 18, 2011 5:16 pm ]
Post subject:  Log file output

Output log, text only, does not capture all the supported characters.

Author:  profkelly [ Thu May 19, 2011 3:50 pm ]
Post subject: 

The ASCII characters $20 thru $7F were the same in the display and log file in a quick test I ran. Which characters are missing?

Author:  lee [ Thu May 19, 2011 9:38 pm ]
Post subject: 

Sorry, I should have been clearer. It's the supported control characters, except [CR] and [LF], that don't get captured.

Lee.

Author:  profkelly [ Thu May 19, 2011 11:58 pm ]
Post subject: 

Next question,

Currently the simulator supports the following control chars:

$07 Bell
$08 Backspace
$09 Horizontal Tab
$0A Line Feed
$0B Vertical Tab
$0C Form Feed
$0D Carriage Return

The only control character sent to the log file is $0A Line Feed.

Should the above control characters simple be written to the log file?

Should all characters $00 through $FF be written to the log file?

Author:  lee [ Fri May 20, 2011 8:50 am ]
Post subject: 

Quote:
The only control character sent to the log file is $0A Line Feed.

.. and it's sent as two characters $0D,$0A which, as I usually either explicitly prefix all line feeds with carriage returns or use tasks that do, I hadn't noticed.

Quote:
Should the above control characters simple be written to the log file?

Should all characters $00 through $FF be written to the log file?

I think that all supported characters that are output to the screen should be written to the log file as they are. That way the user has an accurate log of what was output.

Lee.

Author:  profkelly [ Mon May 23, 2011 11:55 pm ]
Post subject:  Log output

Sim68K v5.11.0

Logs all characters written to screen. (I hope)

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/