|Page 1 of 1|
|Author:||gwg [ Tue Jul 16, 2019 6:29 pm ]|
I believe that the "hardware" reset exception is generated by pressing the "reset button" on the hardware GUI.
However, when I do this, I notice that the SSP is updated correctly, but the PC appears to be off by 4 (and even on one occasion 6).
I have included a few lines of code below.
DC.L $00E000 ;SP_INIT
DC.L $008000 ;PC_INIT
Once loaded and executed, the supervisor SP is initialized to SS=0000E0000, but the PC is initialized to 00008006.
Any insights? Thanks.
|Author:||profkelly [ Mon Jul 22, 2019 11:13 pm ]|
|Post subject:||Re: Rest|
In Sim68K make sure "Enable Exceptions" in the Options menu is checked.
|Page 1 of 1||All times are UTC|
|Powered by phpBB® Forum Software © phpBB Group