EASy68K
http://www.easy68k.com/EASy68Kforum/

TextPad Compatibility?
http://www.easy68k.com/EASy68Kforum/viewtopic.php?f=6&t=1018
Page 1 of 1

Author:  bissell.michael [ Wed May 18, 2011 5:05 pm ]
Post subject:  TextPad Compatibility?

Hello,

I was working on a way to separate the 68k Editor/Assembler so that I could call just the Assembler through the command line. This would enable me to set up a TextPad tool for Assembling & Debugging. Would the best way be to compile without including the current editor header files?

Thanks,
Michael

Author:  profkelly [ Wed May 18, 2011 9:30 pm ]
Post subject: 

The Teesside Assembler/Simulator uses a command line interface. You can download it here:
http://www-scm.tees.ac.uk/users/a.clements/install.exe

Author:  bissell.michael [ Mon May 23, 2011 3:48 pm ]
Post subject: 

Thanks,

I've run into that assembler before. I like the 68k as a learning tool. Maybe I can compile with Teeside and Debug with 68k. Would the assembled code with Teeside be exactly the same?

I have an open source project report next term and had a question about porting 68k to Linux...would that be a project that would be beneficial?

Thank you,
Michael :idea:

Author:  profkelly [ Mon May 23, 2011 5:52 pm ]
Post subject: 

Code created in Teeside will run on EASy68K.

There is a partial port of EASy68K to Linux.
Linux Port

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/